Controlling TVs with the remote
You can adjust the remote control's signal to
control your TV.
If you connected the recorder to an AV amplifier
(receiver), you can also nse the supplied remote to
control the AV amplifier's (receiver's) volume.
I l_I_;_-]_
• Depending on the connected unit, you may not be able
to conuol yore TV or AV amplifier (receiver) with
some or all of the buttons below.
• If you enter a new code nmnber, the code nmnber
previously entered will be erased
• When you replace the batteries of the remote, the code
nmnber may be reset to _lledefa:flt setting. Set the
appropriate code number again
..................................TV/DVD.VIDEO
switch
a o..............g¢
i
C_ ..............TVNIDEO
iili ZZ:i ZIII:CZi ii
1 Slide the TV/DVD.VIDEO switch to TV.
2 Hold down I/(_.
3 EnteryourTV'smanufacturercode(see
below)using thenumberbuttons.
4 ReleaseI/(_.
When the TV'DVD.VIDEO switch is set to
TV, the remote perlbrms the following:
Press To
II0 Turn yourTV on o1off
VOL _ Adjust the volume of
yore" TV
CH +_ Select the channel on
yo:L:TV
TV VIDEO Switch your TV's input
sotLrce
Nmnber buttons and Select the channel on
SET your TV
Code numbers of controllable TVs
If more than one code m:mber is listed, try
entering them one at a time until you find the one
that works with your TV.
Manufacturer Code number
So W 01 (de±Zault)
Akai 04
AOC 04
Centurion 12
Coronado 03
Cmtis-Mathes 12. 14
Daewoo 04, 22
Da?_ron 03, 12
Fisher 11
General Electric 04, 06, 10
Hitachi 02, 03, 04
J.C.Penney 04, 10, 12
JVC 09
KMC 03
LG Gold Star 03, 04, 17
Magnavox 03.04, 08 12, 21
Marantz 04, 13
MGAiMitsubishi 04, 12, 13 17
NEC 04. 12
Panasonic 06, 19
Philco 02.03, 04. 08
Philips 08, 21
Pioneer 06, 16
Portland 03
Proscan 10
Quasar 06, 18
Radio Shack 05. 10, 14
R(A 04. 10
Sampo 12
Salnsung 03, 04, 12. 20
Sanyo 11, 14
Scott 12
Sears 07, 10, 11
Shm_ 03.05, 18
212
O
g
•._continued 27
To Next Page
Loading...
