Soundcraft Vi6™ User Guide Page 11 - 9
Figure 11-7: User A Patch Page
The USER A and USER B patch pages allow an alternative monitor source to the normal LR or LCR mix, to
be set up.
This can be used, for example, to allow the user to listen to a favourite monitor mix, whenever a solo is not
pressed (select an Aux bus from the Bus Out page, as shown above).
Another application is to allow an input from the Stagebox to be used as a ‘shout’ talkback line: if the
relevant Stagebox input is selected as the User A or B source, this can be monitored whenever no desk
solos are being monitored.
The User A and User B sources are normally stereo, but a mono source can be used by patching the
same source to L and R channels in the patch page shown above.
To Next Page
Loading...
Need help?
General
