Soundcraft Vi6™ User Guide Page 5 - 9
CHANGING OUTPUT BUS PARAMETERS
The following pages shows bus master processing using the Input strip (All Busses layer) mode as an
example. Parameter changing is done in the same way if either of the other two ways of accessing bus
masters is used.
Changing A Parameter Of A Bus
* Press the desired touch field, the corresponding VST Area will open
* change the parameter
* Press the touch field again to go back to the default VST view
or
* Press another touch field.
Figure 5-8: The Relationship Between Touch Fields And Master Functions.
To Next Page
Loading...
Need help?
General
