SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
3 – Getting Started
37
Input modes
All characters can be entered in a data input field. The maximum length of character of a point ID or
point number is 16.
Press [<] to delete one character to the left of the cursor.
When the data is wider than the screen, the data automatically moves to the left.
When an A is displayed on the upper right corner of the screen, letters can be entered using the
keypad. When
1 is displayed, numbers can be entered. In any measurement screen or screens that
need manual input, press
[MODE] to shift between alpha mode and numeric mode.
In alpha mode, three letters are set using one key. Each key press displays the next letter for that key
in the cursor.
The methods for Code (CD) input are; enter manually, select from a list and select from a stack. The
operational methods are the same as that of entering a point.
Entering characters
1. Ensure that the current input mode is alpha mode. If not,
press
[MODE].
2. Press [6] three times to enter R .
3. Press [6] once to enter P.
4. Press [MODE] to change to numeric mode.
5. Press [1] and [6].
6. Press [REC/ENT] to confirm.
B
Tip – If the point ID is wrong, press [ESC] and enter it
again.
Editing characters
Characters that have been entered can be edited.
1. Move the cursor to the item that needs to be edited, and
press
[>]. The cursor stays on the first character and
flashes.
2. Press [>] to move the cursor to the character that needs to
be edited.
3. Enter the new character.
4. Press [REC/ENT] to confirm. The cursor moves to the next item.
B
Tip – Press [<] to delete the right character.
To Next Page
Loading...
Need help?
General
