Spectra Precision FOCUS 2 Series - Entering Coordinates Manually; Settings

SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
6 – Menu Key
110
Entering coordinates manually
1. From the Cogo menu, press [5] (or press [v] and [REC/ENT])
to select InputXYZ.
A point input screen appears.
2. Enter the coordinates using the numeric keys. To move to
the next field, press
[REC/ENT] or [v] in a field.
3. Press [REC/ENT] in the Z field to save the point as a
manually input record. The display returns to the point input screen. The default PT is
incremented to the next value.
Settings
See also Job settings, page 102.
1. From the main menu, press [3] (or press [v] + [REC/ENT]) to select Set.
The Settings menu appears.
2. Press [v] / [v] + [REC/ENT] or the numeric key to select the
item for which settings are to be made. This procedure
uses the Angle setting as an example.
3. To open the Angle menu, press [1].
4. Press [v] / [v] to move to items that need to be changed.
5. Press [>] / [<] to change the settings, and then press [REC/ENT].
6. If any of these settings are changed while a job is open, a confirmation screen appears prompting
for the current job to be closed. Press
Abrt to use the settings in the current job and cancel the
change. Press
OK to close the job. Then, in the measure or record function, the program will
prompt you to select or create a job.
The display returns to the Settings menu.
In the following list, items shown in bold italics cannot be changed once a job is created.
Item Options
Angle VA0: Zenith, Vertical, Vert ±90
Min: Ang 1'', 5'', 10''
HA: Azimuth, 0 to BS
When this field is set to Azimuth, the horizontal angle (HA) that is displayed and recorded is an
Azimuth value.
When this field is set to 0 to BS, HA is in HA zero to BS value.