Spectra Precision FOCUS 2 Series User Manual

SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
5 – Applications
61
Quick station
Use this option to set up a station quickly without coordinates.
The station point (ST) in this function defaults to a new point number. For the new point, MP (0, 0, 0)
is stored as the coordinates. When the ST is manually changed to a known point name, the station is
set up on the coordinates of the known point.
Even if both ST and BS are known points, this function does not calculate the backsight angle (AZ)
automatically. To calculate the AZ between two known points (ST and BS), select Station Setup /
Known.
1. From the Stn Setup menu, press [3] (or press [v] and
[REC/ENT]) to select QuickStn.
The QuickStn screen appears.
2. Enter the ST point name and then press [REC/ENT]. The
station point defaults to the last recorded PT + 1, or ST + 1,
depending on the Split ST setting.
3. Enter the height of the instrument and then press
[REC/ENT].
4. No default PT is assigned to the BS. Leave this field blank,
or enter a BS point name.
5. The backsight azimuth (AZ) defaults to zero, but this can
be changed.
6. To complete the station setup, sight the BS and press [REC/ENT].
When you press [REC/ENT] in the AZ field, both HA and AZ are reset to the value you have entered.
Note – For the Split ST setting, see Settings, page 110.

Spectra Precision FOCUS 2 Series Specifications

General

Brand	Spectra Precision
Model	FOCUS 2 Series
Category	Measuring Instruments
Language	English