SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
5 – Applications
70
4. Move the rodperson to the target position. When the target is on the intended position, the
displayed errors become 0 m (or 0
ft).
An up arrow signifies to move away from the station (OUT).
A down arrow signifies to move towards the station (IN).
5. If the third line L/R does not display 0 m, move the rodman to the target position.
An arrow pointing to the right shows that the rodman moves to their left side.
An arrow pointing to the left shows that the rodman moves to their right side.
When both R/L and IN/OUT display 0 m, it indicates the prism is on the stakeout point.
6. After staking out, press [REC/ENT] to record the stakeout point. PT defaults to the last recorded
PT+1, and a CD (code) may also be entered if required.
7. After recording the point, the display returns to the SO screen. Press the Prev / Next softkeys
or use
[^] or [v] to stakeout other divided points.
RefLine stakeout
This function allows a point to be staked based on the Sta, O/S, and dZ to a specified line.
1. From the SO menu, press [4] (or press [v] and [REC/ENT]) to
select RefLine.
The Input P1 screen appears.
2. Enter the first point (P1) of the line and press [REC/ENT].
Note – If [REC/ENT] is pressed without entering a PT name,
temporary coordinates can be entered which are not
recorded in the job. Alternatively, press the
MSR softkey to
measure a point.
3. Enter the second point (P2) of the line.
4. Enter offsets to the line. Press [REC/ENT] in a blank field to enter the value 0.0000.
Sta Distance from P1 along the line
O/S Offset to the refline
(+) Right side of the P1-P2 line
(-) Left side of the P1-P2 line
dZ dVD to line
To Next Page
Loading...
