SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
5 – Applications
71
5. Start the stakeout. Rotate the instrument until the dAZ is
0°00'00".
6. Sight the target and press [MSR1] or [MSR2].
7. After measuring, the deviation value between measured
point and stakeout point is shown.
8. Move the rodman to the target position. When the target is on the intended position, the
displayed errors become 0.000 m (or 0.000
ft).
An up arrow signifies to move away from the station (OUT).
A down arrow signifies to move towards the station (IN).
When both R/L and IN/OUT display 0 m, it indicates the prism is on the stakeout point.
The fifth line shows the Cut/Fill data.
9. After staking out, press [REC/ENT] to record the stakeout point. PT default to the last recorded
PT+1, and a CD (code) can be entered if required.
10. After recording, the point, the display returns to the SO screen. Press [ESC] to re-enter the offsets.
Repeat
Step 4 through Step 9 to carry out a Ref.Line stakeout.
All observation results appear in 8 screens: Press [v] or the DSP softkey to switch between display
screens. For more information, see
Stakeout by angle and distance, page 64.
Note – To input PtID, see Entering a point name or number, page 38.
dAZ Azimuth error to target point
HD Horizontal distance to the target point
dHA Difference in horizontal angle to the target point
R/L Right/Left (Lateral error)
IN/OUT In/Out (Longitudinal error)
CUT/FILL Cut/FilL
To Next Page
Loading...
