Spectra Precision FOCUS 2 Series User Manual

SPECTRA PRECISION FOCUS 2 SERIES TOTAL STATION USER GUIDE
4 – Routine Measurements
46
To sel ect a target set:
1. From the HOT key menu, press [3] (or press [v] and [REC/ENT])
to select TGT.
The TGT screen appears.
2. Either press the corresponding numeric key (from 1 to 5),
or use
[v] or [^] to highlight the target set in the list and press
[REC/ENT]. To change the settings defined in a target set,
highlight the target set in the list and then press the
Edit
softkey.
When a target set is selected, the Type and Const values are
copied to both
[MSR1] and [MSR2] settings. If you have specified a value for HT, this value is also
copied to the current HT.
3. After editing, press [REC/ENT].
The system stores the target set, and returns to the Basic Measurement screen.
Type prism/non prism/reflector sheet
Const –999 to 999 mm
HT –9.990 to 99.990 m
Note – “HT” can be left blank in the target set (input the number beyond the maximum
instrument height). If you leave it blank, the current HT value is always applied to the
measurement.

Spectra Precision FOCUS 2 Series Specifications

General

Brand	Spectra Precision
Model	FOCUS 2 Series
Category	Measuring Instruments
Language	English