Instruction Manual
for
AS380 Series Elevator Integrated Drive Controller
31
8．Pre-close the Door by Door-closing Button
when the door is open in automatic state, the door can be closed immediately before the delay
elapses by pushing on the door-closing button.
9．Open the door by Door-opening Button
when the car stays within the door zone, a passenger in the car can open a closed door or make a
closing door reverse by pushing on the door-opening button.
10．Door Selection
you may set parameter to select different door machine, which includes such types as
opening-torque hold, closing-torque hold and opening/closing-torque holding.
11．Leveling on Changing Destination landing
if the door has been opening longer than the setting time without activating the door open limit
switch, the door will close and the elevator will travel to the next floor after the door is closed.
12 Cancel a Wrong Registration
if a passenger realizes that he or she has pushed down a wrong button in the car panel, he or she
can cancel the wrong registration by pushing the same button twice incessantly.
The registered signal will be canceled. This function can be activated by the parameter setting.
13．Clear Registrations at Changing Direction
when the elevator car arrives at the last landing and is about to reverse the direction, all the
registrations behind its present travel will be cancelled at once.
14．Direct landing
the control system decelerates the elevator according to distance principle. No creeping when
leveling.
15 full load by pass
When a full-loaded elevator car travels in automatic mode without attendant, the elevator will
NOT answer any calls from its passing landings, stopping at the landings by in-car registrations
only.
16 Power-off for Car Lighting and Fan at Stand-by
If a elevator in automatic mode stands by out of service over 3 minutes (default value of 3
minutes subject to change by parameter), receiving neither in-car nor landing calls, the car lighting
and fan will automatically stays off power until a call for the elevator to answer appears.
17. Auto Homing
When the elevator travels in automatic mode without attendant service while setting Auto Homing
in effect, the elevators which receives neither in-car nor landing calls will automatically return to
the main landing within a given period of time determined by parameter setting.
18．Re-close door
In order to prevent door-closing failure from the contingent failure of the door machine system
and possible door block by something, this function is therefore provided to re-close the door.
19．Fault history Log
The Fault history Log keeps the latest 20 fault records concerning the occurrence time, floors and
fault codes.
To Next Page
Loading...
Need help?
General
