Instruction Manual
for
AS380 Series Elevator Integrated Drive Controller
32
20 hoist way landing data self-study
the hoist way self-study system should be activated before the elevator goes into service. The
system will study various kinds of data within the hoist way and save those running data
permanently.
21 Service Landing arbitrarily Setting
Using the handheld operator to set at will which floors the elevator serves and which floors the
elevator does NOT serve.
22 Indicating Symbols Setting for Landing Display
Using the handheld operator to set at will the varied display symbols or marks for each floors, for
instance, “B” for underground ONE.
23 Attendant Service
using the switch in the car operation panel, one can put the elevator into attendant service, under
which the automatic door closing is absent and the door can only be closed when attendant keep
pressing the door-closing button. Meanwhile the function can also allow attendant to choose
direction and by-passing.
24 Independent Travel
Independent Travel is an exclusive travel, during which the elevator overlooks all landing calls
and the automatic door-closing is absent. Other features are similar to Attendant Service.
25 Dot-matrix Landing Indicators
Dot-matrix Landing Indicators are used both in the car and on the landing, displaying such
information as the floor position, running direction, elevator status and etc
26 emergency elevator returning against fire
When encountering fire, passenger set the fire returning switch in position. Elevator
immediately cancels all the instruction and call and travel to firefighting station for door-opening
and stand-by.
27 Automatic Correction in Landing Position Signals
the traveling elevator system compare its own position signals at each terminal switch and the
leveling switch of each landing against those obtained by self-study and making automatic data
corrections accordingly.
28 Elevator Lock-in
setting the lock-in switches of elevator in automatic mode or with attendant, and clear up all the
registration call. The elevator only respond to the in-car instruction until no new instructions
registered. Then the elevator returns to the base station, turns off in-car lighting and fan after
opening the door automatically, lighten the door-opening button indicator, and automatically close
the door when 10 seconds time delay expired. Finally, the elevator stops running, and will be back
to operation when the lock-in switch reset.
29 Protection against Door-opening outside Door Zones
The door cannot open outside the door zone, which is preset by the system for safety concern.
30 Light Gate Protection for Doors
every elevator is equipped with a light gate door protection, whenever any object appears or stays
To Next Page
Loading...
Need help?
General
