STOBER 3 | General safety instructions
02/2019 | ID 442728.05
15
3 General safety instructions
There are risks associated with the product described in this documentation that can be
prevented by complying with the described warning and safety instructions as well as the
included technical rules and regulations.
3.1 Directives and standards
The following European directives and standards are relevant to the drive controllers:
§ Machinery Directive 2006/42/EC
§ Low Voltage Directive 2014/35/EU
§ EMC Directive 2014/30/EU
§ EN 61326-3-1:2008
§ EN 61800-3:2004 and A1:2012
§ EN 61800-5-1:2007
§ EN 61800-5-2:2007
§ EN 50178:1997
§ IEC 61784-3:2010
Subsequent references to the standards do not specify the respective year in order to improve
readability.
3.2 Qualified personnel
In order to be able to perform the tasks described in this documentation, the persons instructed
to perform them must have the appropriate professional qualification and be able to assess the
risks and residual hazards when handling the products. For this reason, all work on the products
as well as their operation and disposal may be performed only by professionally qualified
personnel.
Qualified personal are persons who have acquired authorization to perform these tasks either
through training to become a specialist and/or instruction by specialists.
Furthermore, valid regulations, legal requirements, applicable basic rules, this documentation
and the safety instructions included in it must be carefully read, understood and observed.
3.3 Intended use
As defined by DIN EN 50178, SC6 drive controllers and PS6 supply modules are electrical
devices operating as power electronics to control the flow of energy in high-voltage systems.
The SI6 drive controller intended solely for the operation of STOBER LM series Lean motors,
synchronous servo motors (e.g. from the STOBER EZ series), asynchronous motors or torque
motors.
The PS6 supply module is intended solely for the supply of one or more drive controllers. Only
drive controllers of the 6th generation of STOBER drive controllers may be connected to the
PS6.
To Next Page
Loading...
