3 | General safety instructions STOBER
16
02/2019 | ID 442728.05
The connection of other electronic loads or operation outside applicable technical specifications
constitutes improper use.
When installing drive controllers in machines, commissioning (i.e. commencing intended
operation) may not be performed until it has been determined that the machine is in compliance
with provisions from the following EC and EU directives:
§ Machinery Directive 2006/42/EC
§ Low Voltage Directive 2014/35/EU
§ EMC Directive 2014/30/EU
EMC-compliant installation
The SI6 drive controller and accessories must be installed and wired compliant for EMC
Modification
As the user, you may not make any physical, technical or electrical modifications to the SI6
drive controller and the accessories.
Maintenance
The SI6 drive controller and accessories are maintenance-free. For the safety module, take
appropriate measures to detect or prevent possible errors in the connection wiring.
Product life span
A drive controller with integrated safety module must be taken out of operation 20 years after
the production date. The production date of the drive controller is found on the accompanying
nameplate.
3.4 Transport and storage
Inspect the delivery for any transport damage immediately after you receive it. Notify the
transport company of any damage immediately. Do not put a damaged product into operation.
To ensure the faultless and safe operation of the products, they must be professionally
configured, installed, operated and maintained. If you have to transport or store the products,
you must protect them from mechanical impacts and vibrations as well as observe the
recommended transport and storage conditions in the technical data.
Store the products in a dry and dust-free room if you do not install them immediately.
3.5 Operational environment and operation
The products are subject to sales restrictions in accordance with IEC 61800-3.
The products are not designed for use in a public low-voltage network that supplies residential
areas. Radio-frequency interference can be expected if the products are used in this type of
network.
The products are designed exclusively for operation in TN networks.
The products are intended exclusively for installation in control cabinets with at least protection
class IP54.
Always operate the products within the limits specified by the technical data.
To Next Page
Loading...
