STONEX R6 Series - Distance Offset

R6,Functions
33
6.2 DistanceOffset
Description
Thisfunctioncalculatesthetargetpointcoordinatesifitisnotpossibletosetupthereflector,
ortoaimatthetargetpointdirectly.Theoffsetvalues(length,trav.and/orheightoffset)canbe
entered.Thevaluesfortheanglesanddistancesarecalculatedtodeterminethetargetpoint.
Access
1) PressFNCwhenwithinanyapplication.
2) SelectDistance OffsetfromtheFUNCTIONSmenu.
DISTOFF
MP Measurementpoint
OP Offsetpoint
T_Off Lengthoffset
L_Off Crossoffset
DEFLT
Toresetoffsetvaluesto0.
Field Description
Trav.
Offset
Perpendicularoffset.Positiveiftheoffsetpointistotherightofthemeasured
point.
Length
Offset
Longitudinaloffset.Positiveiftheoffsetpointisfurtherawaythanthemeas‐
uredpoint.
Z-Offset Heightoffset.Positiveiftheoffsetpointishigherthanthemeasuredpoint.
Mode Periodforwhichtheoffsetistoapply.
0 after REC Theoffsetvaluesareresetto0afterthepointissaved.
Continuous Theoffsetvaluesareappliedtoallfurthermeasurements.
)
Theoffsetvaluesarealwaysresetto0whentheapplicationisquit.
MP
OP
L_Off -
L_Of
T_Off -
T_Off+