STONEX R6 Series - Manual Orientation; Orientation with Coordinates

R6,Applications - Getting Started
43
Access
SelectSelect Orientn. inthe Pre-settings screenandchoose:
• Angle Toenteranewbearing.Referto"8.5.2ManualOrientation".
• CoordinatesTocalculateandsettheorientationusingexistingcoordinates.A
maximumoffivetargetpointscanbeused.Referto"8.5.3OrientationwithCoordi‐
nates".
8.5.2 ManualOrientation
Access
SelectAngleintheSTN.ORIENTATIONscreen.
MANUALANGLESETTING
Nextstep
• Either,pressALLtomeasureandrecordthedistanceandhorizontalangles.Thiswill
calculateandsettheorientationandreturntothePre-Settingsscreen.
• Or,pressRECtorecordthehorizontaldirectiononly.Thiswillsettheorientationand
returntothePre-Settingsscreen.
8.5.3 OrientationwithCoordinates
Diagram
HA=0
TosetBrg:0
Field Description
Brg Horizontaldirectionofthestation.
TgtHGT. Heightofthereflector.
BS ID PointIDofthebacksightpoint.
Known coordinates
1Targetpoint
2Targetpoint
3Targetpoint
Calcuations
HA1Stationorientation
HA=0
HA1