STONEX R6 Series - Reference Element - Reference Arc; Overview

R6,Applications
52
Messages
Thefollowingareimportantmessagesorwarningsthatmayappear.
Nextstep
• Either,pressALLtomeasureandrecord.
• Or,press BACKtoreturntotheREFERENCE LINEscreen.
•Or,continueselectingESCtoexittheapplication.
9.4 ReferenceElementReferenceArc
9.4.1 Overview
Description
TheReferenceElement‐Arcapplicationallowstheusertodefineareferencearcandthen
completethefollowingtaskswithrespecttothearc:
• Line&offset
• Setout(Point,Arc,Chord,Angle)
Access
1) SelectAppsfromtheMAIN MENU.
2) SelectReference ElementfromtheAPPSmenu.
d.d.Z Heightdifferencefromthemeasuredpointtothesetoutpoint.Positiveiftheset
outpointishigherthanthemeasuredpoint.
dOffset Perpendiculardistancefromthemeasuredpointtothesetoutpoint.Positiveifthe
setoutpointistotherightofthemeasuredpoint.
dLine Longitudinaldistancefromthemeasuredpointtothesetoutpoint.Positiveifthe
setoutpointisfurtherawaythanthemeasuredpoint.
Messages Description
Base line too short ! Baselineisshorterthan1 cm.Choosebasepointssuchthatthehori‐
zontalseparationofbothpointsisatleast1 cm.
Coordinates invalid ! Nocoordinatesorinvalidcoordinatesforapoint.Ensurethatpoints
usedhaveatleastEastingandNorthingcoordinates.
Save via RS232 ! Data Output:issettoRS232intheSETTINGSmenu.Tobeable
tosuccessfullystartreferenceelement,Data Output:mustbeset
toInternal.
Field Description