STONEX R6 Series - Page 51

R6,Applications
51
Example orthogonal setout
Access
PressSETOUTfromthe REFERENCE LINEscreen.
SETOUT
Enterthesetoutelementsforthetargetpointstobesetoutrelativetothereferenceline.
Nextstep
PressOKtoproceedtomeasurementmode.
SETOUT
Thesignsforthedistanceandangledifferencesarecorrectionvalues(requiredminusactual).
Thearrowsindicatethedirectiontomovetogettothesetoutpoint.
1RP1streferencepoint
SP Setoutpoint
MP Measuredpoint
RL Referenceline
dL Longitudinaloffset
dO Paralleloffset
Field Description
Line Longitudinaloffset:Positiveifsetoutpointisfurtherawayfromthereference
line.
Offset Perpendicularoffset:Positiveifsetoutpointistotherightofthereferenceline.
Z Heightoffset:Positiveifsetoutpointishigherthanthereferenceline.
NextPt
Toaddthenextpointtobesetout.
Field Description
d HA Horizontaldirectionfromthemeasuredpointtothesetoutpoint.Positiveifthe
telescopemustbeturnedclockwisetothesetoutpoint.
d.H.D Horizontaldistancefromthemeasuredpointtothesetoutpoint.Positiveiftheset
outpointisfurtherawaythanthemeasuredpoint.
1RP
RL
SP
MP
d L-
d O-