STONEX R6 Series - Defining the Reference Arc

R6,Applications
53
3) Completeapplicationpre‐settings.Referto"8Applications‐GettingStarted".
4) SelectArc.
Nextstep
Definethereferencearc.
9.4.2 DefiningtheReferenceArc
Description
Thereferencearccanbedefinedbyacenterpointandstartpoint,orastartpoint,endpoint,
andradius.Allpointscanbeeithermeasured,manuallyentered,orselectedfromthememory.
)
Allarcsaredefinedinaclockwisedirectionandallcalculationsaremadeintwodimensions.
Access
SelectArcandthenthemethodtodefinethearcby:
• Start-/ Centre Pt.
• Start-/ End Pt/ Rad.
ReferenceArcMeasuretostartpoint
Nextstep
AfterdefiningthereferencearctheREFERENCE ARCscreenwillappear.
SP Startpoint
EP Endpoint
CP Centerpoint
RRadiusofarc
L Distancefromstartofarc,followingcurve
Off Perpendiculardistancefromarc
Field Description
Start Pt PointIDofthestartpoint.
C-Pt PointIDofthecenterpoint.
End Pt PointIDoftheendpoint.
Radius Radiusofthearc.
CP
SP
R
L+
Off -
EP
P