STONEX R6 Series - Z-Coordinate; 2 Dist. Offset

R6,Functions
34
Nextstep
• PressOKtocalculatethecorrectedvaluesandreturntotheapplicationfromwhichthe
offsetfunctionwasstarted.Thecorrectedangleanddistancesaredisplayedassoonasa
validdistancemeasurementhasbeentriggeredorexists.
6.3 ZCoordinate
Description
Thisfunctiondeterminestheheightoftheinstrumentfrommeasurementstoamaximumoffive
targetpoints,withknownheights,intwofaces.
Withmeasurementstoseveraltargets,theimprovementisindicatedinthe"d"value.
Access
1) PressFNCwhenwithinanyapplication.
2) SelectZ-CoordinatefromtheFUNCTIONSmenu.
ZCoordinatestepbystep
1) Selectaknownpointandinputthereflectorheight.Select;
• PtHgt:Toentertheheightofafixpoint.
• Inst.h.:Toentertheheighttransfervaluesfortheinstrument.
2) PressALLtocompletethemeasurementanddisplaythecalculatedheight.
• AddTg:Addsanotherheightofaknownpoint.
• FACE:Measurestothesametargetinsecondface.
• OK:Savesthechangesandsetsthestationheight.
6.4 2Dist.Offset
Description
Thisfunctionisusedformeasurementstoapointthatisnotdirectlyvisible,usingaspecial2
Dist.Offsetpole.
1Reflector1
2Reflector2
3Reflector3
4Instrument
STn.Z