STONEX R6 Series - Working with the Battery

R6,Operation
16
6 AcceptwithOK.
Changetheintensityofthelaserplummet
Externalinfluencesandthesurfaceconditionsmayrequiretheadjustmentoftheintensityof
thelaserplummet.
Positionoverpipesorholes
3.2 WorkingwiththeBattery
)
Charging/firsttimeuse
• Thebatterymustbechargedpriortousingitforthefirsttimebecauseitisdeliveredwith
anenergycontentaslowaspossible.
• Fornewbatteriesorbatteriesthathavebeenstoredforalongtime(>threemonths),itis
effectualtomakeonlyonecharge/dischargecycle.
• Thepermissibletemperaturerangeforchargingisbetween0°Cto+40°C/+32°Fto
+104°F.Foroptimalchargingwerecommendchargingthebatteriesatalowambient
temperatureof+10°Cto+20°C/+50°Fto+68°Fifpossible.
• Itisnormalforthebatterytobecomewarmduringcharging.Usingthechargersrecom‐
mendedbyStonex
®
,itisnotpossibletochargethebatteryifthetemperatureistoohigh.
)
Whentheelectronicleveliscenteredandthree
checkmarksareshown,theinstrumenthasbeen
perfectlylevelledup.
IntheLevel & Plummetscreen,adjustthe
intensityofthelaserplummetusingthenaviga‐
tionkey.
Thelasercanbeadjustedin25%stepsas
required.
Undersomecircumstancesthelaserdotisnot
visible,forexampleoverpipes.Inthiscase,
usingatransparentplateenablesthelaserdotto
beseenandtheneasilyalignedtothecenterof
thepipe.
Zoom_005