STONEX R6 Series - Control Distance

R6,Functions
36
Nextstep
PressENDtoreturntotheapplicationwhereFNCwasselected.
6.5 ControlDistance
Description
Thisfunctioncalculatesanddisplaystheslopeandhorizontaldistance,heightdifference,
azimuth,grade,andcoordinatedifferencesbetweenthelasttwomeasuredpoints.Valid
distancemeasurementsarerequiredforthecalculation.
Access
1) PressFNCwhenwithinanyapplication.
2) SelectControl Distance fromtheFUNCTIONSmenu.
CONTROLDISTANCE
Messages
Thefollowingareimportantmessagesorwarningsthatmayappear.
Azi Azimuth
SD Slopedistance
VD Heightdistance
HD Horizontaldistance
Field Description
Brg Differenceinbearingbetweenthetwopoints.
Grade Differenceingradientbetweenthetwopoints.
hDIST Differenceinhorizontaldistancebetweenthetwopoints.
sDIST Differenceinslopedistancebetweenthetwopoints.
d.d.Z Differenceinheightbetweenthetwopoints.
Messages Description
Less than two valid
measurements!
Thevaluescannotbecalculatedastherearelessthantwovalid
measurements.
Azi
SD
VD
HD
N