STONEX R6 Series - Subapplication Measure Line & Offset; Subapplication Setout

R6,Applications
54
REFERENCEARC
Nextstep
Selectasoftkeyoption,MEASorSET OUT,toproceedasubapplication.
9.4.3 SubapplicationMeasureLine&Offset
Description
TheMeasureLine&Offsetsubapplicationcalculatesfrommeasurementsorcoordinates,longi‐
tudinalandorthogonaloffsetsandheightdifferencesofthetargetpointrelativetothereference
arc.
Access
PressMEASfromtheREFERENCE ARC screen.
Measure
Nextstep
• Either,pressALLtomeasureandrecord.
• Or,press BACKtoreturntotheREFERENCE ARCscreen.
9.4.4 SubapplicationSetout
Description
Thesetoutsubapplicationcalculatesthedifferencebetweenameasuredpointandthecalcu‐
latedpoint.Thereferencearcapplicationsupportsfourwaystosetout:
New
Todefineanewbasearc.
MEAS
TomeasureLine&Offset.
SET OUT
Tosetout.
Field Description
dLine Calculateddistancelongitudinaltothereferencearc.
dOffset Calculateddistanceperpendicularfromthereferencearc.
d.d.Z Calculatedheightdifferencerelativetothestartpointofreferencearc.
• Setoutpoint • Setoutchord
• Setoutarc • Setoutangle