STONEX R6 Series - Applications; Survey

R6,Applications
46
9 Applications
9.1 CommonFields
Descriptionoffields
Thefollowingtabledescribescommonfieldsthatarefoundwithinthefirmwareapplications.
Thesefieldsaredescribedhereonceandnotrepeatedintheapplicationchaptersunlessthe
fieldhasaspecificmeaningwithinthatapplication.
9.2 Survey
Description
Surveyisanapplicationusedforthemeasurementofanunlimitednumberofpoints.Itis
comparabletoSurveyfromtheMAIN MENU,butincludespre‐settingsforthejob,stationand
orientationpriortobeginningasurvey.
Access
1) SelectAppsfromtheMAIN MENU.
2) SelectSurveyfromtheAPPSmenu.
3) Completeapplicationpre‐settings.Referto"8Applications‐GettingStarted".
Field Description
Pt, Pt 1 PointIDofthepoint.
TgtHGT Heightofthereflector.
HA Horizontaldirectiontothepoint.
VA Verticalangletothepoint.
hDIST Horizontaldistancetothepoint.
sDIST Slopedistancetothepoint.
dHGT Heighttothepoint.
E Eastingcoordinateofthepoint.
N Northingcoordinateofthepoint.
Z Heightcoordinateofthepoint.