STONEX R6 Series - 7 Coding

R6,Coding
38
7Coding
Description
Codescontaininformationaboutrecordedpoints.Withthehelpofcoding,pointscanbe
assignedtoaparticulargroupsimplifyinglaterprocessing.
Codesarestoredincodelists,witheachcodelistsupportingamaximumof200codes.
GSIcoding
Codesarealwaysstoredasfreecodes(WI41‐49),thatmeansthatcodesarenotdirectlylinked
toapoint.Theyarestoredbeforeorafterthemeasurementdependingonthesettingmade.
Pointcodes(WI71‐79)arenotavailable.
AcodeisalwaysrecordedforeachmeasurementaslongasthecodeisdisplayedintheCode:
field.Foracodenottoberecorded,theCode:fieldmustbecleared.Thiscanbesettooccur
automatically.Referto"4.1GeneralSettings".
Access
• Either,select Surveyfromthe MAIN MENUandpress CODING.
• Or,pressFNCwhenwithinanyapplicationandselectCode Library.
CODELIBRARY
Extend/editcodes
Toeachcodeadescriptionandamaximumof8attributeswithupto16characterseachcanbe
assigned.Existingcodeattributes,displayedinfieldsText 1:toText 8:,canbeoverwritten
freelywiththefollowingexceptions:
REC
Torecordthecodewithoutmeasurement.
AddLst
Toaddtheenteredcodetothecodelist.
Field Description
Search/New Codename.
Afterentry,thefirmwaresearchesforamatchingcodename,anddisplays
theseinthecodefield.Ifamatchingcodenamedoesn’texistthisvalue
becomesthenewcodename.
Code Listofexistingcodenames.
Comment Additionalremarks.
Text1 to
Text8
Moreinformationlines,freelyeditable.Usedtodescribeattributesofthe
code.