STONEX R6 Series - Construction; Starting Construction

R6,Applications
70
Access
1) SelectAppsfromtheMAIN MENU.
2) SelectRemote ElevationfromtheAPPSmenu.
3) Completeapplicationpre‐settings.Referto"8Applications‐GettingStarted".
Remoteelevationmeasurement
Measuretothebasepointorpress Tgt.H=?todetermineanunknownreflectorheight.
Nextstep
Aftermeasuring,the REMOTE ELEVATIONscreenappears.
REMOTEELEVATIONAimatremotepoint
Aimtheinstrumentattheinaccessibleremotepoint.
Nextstep
• Either,pressOKtosavethemeasurementoftheremotepoint.
• Or,pressBACKtoenterandmeasureanewbasepoint.
• Or,pressESCtoexittheapplication.
9.11 Construction
9.11.1 StartingConstruction
Description
Constructionisanapplicationusedtodefineaconstructionsitebycombiningset‐upofthe
instrumentalongaconstructionline,measuringandsettingoutpointsinrelationtotheline.
1 Remotepoint
2 Heightdifference
3Slopedistance
4 Basepoint
Field Description
hDIST Heightdifferencebetweenthebasepointandtheremotepoint.
Z Heightoftheremotepoint.
d.d.Z CalculateddifferenceinHeightbetweenthebasepointandtheremotepoint.