Stratasys Objet260 - Page 163

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-30
5. Whenthefollowingscreenappears,openthecover.
Figure6-30WiperCleaningwizardduringsteps6–10
6. Putonthecleaninggloves.
7. Usingagenerousamountofalcoholonthecleaningcloth,removeany
materialremainingonthewiperandthesurroundingarea.
8. Removeanypiecesofwastematerialcollectedinthepurgeunit.
Ifnecessary,removethewastecollectortocleanit.Wipetherubberseal.
Figure6-31Purgeunitwastecollector
Note: Whenreturningthewastecollectortothepurgeunit,makesureto
insertitasshown.
9. Inspectthewiper.
Ifthewiperisscratched,tornorworn,orifyoucannotcleanit
completely,replaceit.
a. Graspitandpullitupandoutofitsbracket.
b. Insertthenewwiperblade,making sure that it is straight and secured
well on both sides.
10.Inthewizardscreen(seeFigure6-30),confirmthatthewiperbladeis
clean,andclickNext.