Stratasys Objet260 - Page 189

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-56
14.Makesurethatalongwiththehead,youremovethetworubberO-ring
seals.
Figure6-77O-ringsealsontheprinthead
Important
Ifthesealsarenotremovedwiththehead,theyareprobablystucktothe
printblockhousing.Ifso,removethem.
Figure6-78MakingsuretheO-ringsarenotstucktotheprintblock