English
www.stryker.com 2131-009-005 REV A 1-15
Return To Table of Contents
BRAKE / DRIVE / NEUTRAL OPERATION
The bed’s brake system can be used in electronic or manual mode.
Electronic Mode
• To engage one of these systems: press on the “Brake”, “Drive” or “Neutral” button located on the footboard and
on each head siderail.
• To disengage the brake: press on one of the following buttons: “Brake”, “Neutral” or “Drive”.
• To disengage the neutral and drive, press on one of the two buttons not selected.
These systems can also be disengaged using the pedal. To do so, simply flip the pedal to one of the systems not in
use.
Manual Mode
• To engage the brake, drive or neutral system, flip the pedal on the side of the base to the desired system.
• To disengage these systems, flip the pedal to one of the systems not in use. The electronic mode could also be
used to disengage the systems.
WARNING
• Always apply the brakes when a patient is on the bed (except during transport) or entering/exiting the bed. Serious
injury could result if the bed moves while a patient is getting on or off the bed. Once the brake pedal is manually
engaged, push on the bed to ensure the brakes are securely applied.
• To reduce risk of injury, ensure the sleep surface is horizontal and in the lowest position with the siderails fully
raised and locked when moving the bed with a patient in it. To avoid injury to the patient and/or user, do not attempt
to move the bed laterally with the Drive mode activated; the Drive wheel cannot swivel.
Base Operation Guide
To Next Page
Loading...
Need help?
General
