English
www.stryker.com 2131-009-005 REV A 1-25
Return To Table of Contents
SYSTEM MESSAGE INDICATOR LIGHTS
Note
• The total lockout mechanism blocks the control panel from the siderails, footboard, pendant, touch screen and
head panel (located between the ZOOM
®
Option handles).
• The brake system can be activated during a Total Lockout but it cannot be removed at any moment during a Total
Lockout.
• The Total Lockout does not affect the Nurse Call (optional), Scale System (optional) and Bed Exit Detection
(optional) functions.
• The parameters of the lock mechanism will be saved if there is a power outage and will start from their original
state when the power returns.
Touch Screen
The Nurse Interface can be activated by pressing one of the function buttons or by pressing on the screen itself. After
2 minutes of inactivity, the LCD intensity will lower to about 10% of its maximal level.
If a submenu is opened and no further action is taken by the user, the LCD will shut off completely after 4 minutes (4
minutes = 2 minutes at 100% intensity + 2 minutes at 10% intensity).
Footboard Operation Guide
This indicator shows that the bed is no longer plugged into a wall socket and
that its power comes from the battery.
This indicator shows that the bed is actually plugged into a power outlet and
that the battery is recharging itself. It is highly recommended not to unplug
the bed as long as this LED is on.
This indicator shows that the brakes are not set, which means that the bed
might move if it is pushed or pulled. This LED can be seen as a reminder
to the personnel that the brake needs to be set before leaving a patient
unattended.
This indicator turns on when the power of the battery is at a low level. When
it does turn on, the bed should be plugged in a wall socket to allow the
battery to be recharged.
This indicator shows when the bed needs repairs or maintenance in regards
to its proper functioning. Most of the time the Call Maintenance indicator
will be illuminated when there is a problem with the electronic part of the
bed system. In this case the appropriate maintenance personnel should be
called.
This indicator shows that a part of the bed (Patient Control Only) is locked
or that a total lockout (All Bed Controls) is activated. Refer to page 47 for
the Lockouts menu.
Bed Unplugged:
Bed Charging:
Brake Not Set:
Battery Low:
Call Maintenance:
Locks Enabled: