www.stryker.com 3006-209-001 REV B 13
Introduction
System requirements and recommendations for iBed Wireless (option)
(Continued)
Customer WLAN environment
Required
Channel utilization Consistently less than 30%
Recommended
Signal strength range (minimum) 2.4 GHz: -67dBm +0/-8dBm
5 GHz: -67dBm +0/-8dBm
Yes
Minimum SNR
Minimum 20dB Yes
Priority queuing
Prioritized over best effort traffic
Recommended
Client exclusion
Disabled Recommended
Client load balancing
Disabled Recommended
Max number of SSIDs
5
Recommended
Authentication timeouts
Add session timeout of at least 24
hours
Recommended
Note: A transmit power asymmetry problem may arise at the edges of virtual cell coverage if an APs transmit power is
higher than the Stryker Wireless Client device (~6 mW 2.4 GHz or 12 mW 5 GHz). The received signal strength indicator
(RSSI) of the Stryker iBed Wireless Client on the AP must be verified. The device should never drop below an RSSI of
-75 dBm on the AP.
To Next Page
Loading...
