Name: Stryker S3
Brand: Stryker
Rating: 5 (1 reviews)

To Next Page

To Previous Page

www.stryker.com 3006-209-001 REV B 31

Operation

Activating nurse call communication (option) (Continued)

Note: A 9V battery, located in the head end of the product, powers the nurse call signal. If the product is unplugged

from a wall outlet while the nurse call pendant port switch is set to the on position (Figure 20 on page 31), the charge of

the 9V battery will begin to drain.

If the 9V nurse call battery needs to be replaced, a message will appear on the footboard display. See Replacing the

nurse call backup battery (option) on page 31.

Figure 20: Nurse call switch

Replacing the nurse call backup battery (option)

To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head end of the

bed to the off position. If the switch is not positioned as shown below (A) (Figure 21 on page 32) and the bed power cord

and pendant cord are unplugged, the life of the backup battery will be significantly reduced.

Other manuals for Stryker S3

Questions and Answers:

Need help?

Do you have a question about the Stryker S3 and is the answer not in the manual?

General