www.stryker.com 3006-209-001 REV B 69
FCC notification
Notifications
• FCC ID: Z7A-SDMAN
• IC NO. : 4919E-SDMAN
Notice
Federal Communication Interference Statement (United States Only)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
For product available in the USA/Canada market, only channels 1-11 can be operated. Selection of other channels is
not possible.
If this device is to be operated in the 5.15~5.25GHz frequency range, it is restricted to indoor environments only.
Antenna: Proprietary
Antenna gain information: Embedded Antenna: 2.5dBi (2.4 GHz), 3.5dBi (5 GHz)
Frequency Tolerance+/-20ppm
To Next Page
Loading...
Need help?
General
