Stryker S3 User Manual

52 3006-209-001 REV B www.stryker.com
Operation
Changing the patient weight (Continued)
3. Press and hold the Enter button (F) (see Menu display on page 47) (Figure 48 on page 52) until Release Button
appears (Figure 49 on page 52).
Figure 48: Hold to change patient weight
Figure 49: Release Button
4. Release the Enter button.
Note: Do not touch the product when configuring patient weight (Figure 50 on page 52).
Figure 50: Do not touch bed
5. When the system is ready to change patient weight, press the Up arrow button (C) or Down arrow button (D) to
change the displayed weight (see Menu display on page 47).
6. After changing the weight, press the Enter button (F) (see Menu display on page 47) and the message Patient
Weight Changed will display.
To cancel the request, press the Exit button (E) (see Menu display on page 47) and the message Operation Canceled
will display.
Changing the scale units
You can change the measuring unit to pounds (lb) or kilograms (kg) on your display.
Note: The default scale unit is pounds (lb).
To change the displayed scaled units:
1. Press the Menu button (A). See Menu display on page 47.
2. Scroll to Scale Units.

Stryker S3 Specifications

General

Weight Capacity	500 lbs (227 kg)
Maximum Patient Weight	500 lbs (227 kg)
Bed Frame Material	Steel
Type	Hospital Bed
Bed Width	35 inches (89 cm)
Caster Size	5 inches (12.7 cm)
Electrical Requirements	120 VAC, 60 Hz
Width	35 inches (89 cm)
Power Requirements	120 VAC, 60 Hz
Power Backup	Battery backup available
Accessories	IV pole
Siderails	Yes