www.stryker.com 3006-209-001 REV B 9
Introduction
Specifications (Continued)
Compatible mattress
Thickness Width Length ILD
6 in. 15.2 cm >= 35 in. >= 88.9 cm >= 84 in. >= 213.4
cm
80 lb 36.3
Note: These mattress specifications comply with HBSW and IEC specifications.
Stryker reserves the right to change specifications without notice.
Specifications listed are approximate and may vary slightly from product to product or by power supply fluctuations.
Environmental conditions
Operation Storage and transportation
Ambient temperature
104 °F
(40 °C)
50 °F
(10 °C)
140 °F
(60 °C)
-22 °F
(-30 °C)
Relative humidity (non-condendisng)
Atmospheric pressure
System requirements and recommendations for iBed Wireless (option)
To implement iBed Wireless, follow these requirements for hardware, software, and communication, product
specifications, required settings and recommendations.
Note: If minimum system requirements are not met, system performance will be impacted.
iBed Server requirements for iBed Wireless (option)
The following tables describes the server hardware and software requirements for iBed Wireless:
Hardware requirements
Capacity
Requirement
1-300 connected devices
2.x GHz processor or better with 4 cores
Memory: 8 GB RAM
Hard drive: 150 GB
301-600 connected devices
2.x GHz processor or better with 8 cores
Memory: 16 GB RAM
Hard drive: 150 GB
601-800 connected devices
2.x GHz processor or better with 16 cores
Memory: 32 GB RAM
Hard drive: 150 GB
To Next Page
Loading...
Need help?
General
