12 3006-209-001 REV B www.stryker.com
Introduction
System requirements and recommendations for iBed Wireless (option)
(Continued)
Customer network communication requirements for iBed Wireless option
LAN environment
Client/server communication
IPv4 only Not applicable
Client device IP allocation Static • If Static - Unique IP address will
be required for each client MAC
address
DHCP • If DHCP and not using a DNS
name - Each client MAC address
will need a reserved IP address
• If DHCP and using a DNS name -
It is required to create a unique
name for each client MAC
address for client management
– Stryker recommends using
the Stryker client host name
when the Stryker device
connects to the wireless
network - Example: SYK-
00197b12365 so it may look
like http://SYK-00197b12365.
hosp.org
Server IP allocation Static IP required
Not applicable
VLAN New, existing Install iBed Wireless on a separate
VLAN
IP traffice environment
Source
Protocol / Port number Destination
iBed Server TCP/21 Stryker iBed Wireless Client
iBed Server TCP/80/443 Third party / Stryker back office
iBed Server TCP/1639 Stryker iBed Wireless Client
Third party / Stryker iBed Wireless
Client
TCP/80/443 iBed Server
Customer WLAN environment
Required
Supported wireless vendors Cisco, Aruba
Yes
Access point (AP) types
Controller-based or autonomous
Yes
Channel width 2.4 GHz: 20 MHz
5 GHz: 20/40 MHz
Yes
To Next Page
Loading...
