EasyManuals Logo

Stryker S3 User Manual

Stryker S3
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
www.stryker.com 3006-209-001 REV B 27
Operation
Raising the siderails (Continued)
Figure 14: Siderail highest position
Lowering the siderails
WARNING
Always set the siderail position to make sure that a patient is safely in the product.
Always lock the operator control panel and patient control panel when the patient is unattended.
Always keep the siderails outside of the oxygen tent.
Note: Do not use siderails as a patient restraint device.
To lower the siderail to the intermediate position, grasp the release handle and rotate the siderail forward until it locks
into the intermediate position (Figure 15 on page 27).
Figure 15: Siderail intermediate position
To lower the siderail to its lowest position, grasp the release handle and rotate the siderail forward (Figure 16 on page
28).
Notes
You can stow the siderail under the litter when the siderail is at its lowest position.
Make sure that the siderail is in the lowest position before you raise the siderail directly to the full up position. If you
do not completely lower the siderail, the siderail will lock into the intermediate position when you raise the siderail.

Table of Contents

Other manuals for Stryker S3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stryker S3 and is the answer not in the manual?

Stryker S3 Specifications

General IconGeneral
Weight Capacity500 lbs (227 kg)
Maximum Patient Weight500 lbs (227 kg)
Bed Frame MaterialSteel
TypeHospital Bed
Bed Width35 inches (89 cm)
Caster Size5 inches (12.7 cm)
Electrical Requirements120 VAC, 60 Hz
Width35 inches (89 cm)
Power Requirements120 VAC, 60 Hz
Power BackupBattery backup available
AccessoriesIV pole
SiderailsYes

Related product manuals