www.stryker.com 3006-209-001 REV B 11
Introduction
System requirements and recommendations for iBed Wireless (option)
(Continued)
IEEE 802.11 a/b/g/n
RF bands
2.4 GHz, 5 GHz
Encryption
AES and TKIP
(TKIP is not supported with WPA2)
Authentication WPA Personal / Enterprise and WPA2 Personal /
Enterprise
802.1X
PEAP-MSCHAP - V2
Client certificates Stryker iBed Wireless Client(s) cannot accept or upload
certificates
Supported data rates
802.11b/g: 1-54 Mbps
802.11a: 6-54 Mbps
802.11n: MCS0-6
Channel plan 2.4 GHz: All Channels Supported
5 GHz: All Channels Supported
(Recommend against using DFS and ISM Channels)
Other Stryker iBed Wireless Client is able to connect to an
existing SSID
Client device data usage
• The client uses 10-15 KB per connected device every 40 seconds.
• The client uses an additional 5-21 KB per device for each subscription that is created by a third-party vendor like
Connexall, Capsule, Epic, and Cerner.
Note:
Based on network conditions, device messages are typically sent in near real time or in up to five minutes while
connected. This depends on device activity like applying the brakes, adjusting the rails, alarms, and how the third-party
defines subscription times.
To Next Page
Loading...
Need help?
General
