Subaru Outback 2011 - Page 160

Black plate (165,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
! List of warnings
Inside warning
chime
Outside warning
chime (except
China models)
Access key
warning light on
meter
Operation indi-
cator on push-
button ignition
switch
Status Action
Ding,
ding ...
(intermittent)
———
The driver’s door was opened while
the push-button ignition switch is
“Acc” (in AT and CVT models, when
the select lever is in the “P” posi-
tion).
Switch the push-button ignition
switch to “OFF”, or close the driver’s
door.
*When exiting the vehicle, be sure
to switch the push-button ignition
switch to “OFF”.
The push-button ignition switch was
switched to “OFF” while the driver’s
door is open.
Close the driver’s door.
—
Short beep
(2 seconds)
——
An attempt was made to lock all
doors while the access key is left
inside the vehicle.
Take out the access key from the
vehicle, and lock the doors.
*The doors cannot be locked while
the access key is inside the vehicle.
*A chirp sound will be heard, and all
doors will be unlocked.
The trunk was closed with the
access key in it while all doors are
locked (or during the automatic lock
time period) (Sedan).
Take out the access key from the
trunk, and close the trunk.
*By pressing the trunk opener but-
ton after this warning chime sounds,
the trunk can be unlocked.
The door lock button was pressed
while the push-button ignition
switch is “OFF” and the access key
is inside the vehicle.
Take out the access key from the
vehicle, and lock the doors.
*If the access key is inside the
vehicle, the doors cannot be locked.
—
Beep
(10 seconds)
——
The push-button ignition switch is
pushed while the ignition switch is
in the “OFF” position and one of the
doors including the rear gate is
opened.
Close the doors securely and lock
them.
*If one of the doors including the
rear gate is opened, the doors
cannot be locked.
Instruments and controls
3-33
– CONTINUED –
3