Black plate (168,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
3-36 Instruments and controls
& Immobilizer indicator
light
This light begins flashing under any of the
following conditions.
. Approximately 60 seconds after the
ignition switch is turned from the “ON”
position to the “Acc” or “LOCK” position
(models without “keyless access with
push-button start system”).
. Immediately after the push-button igni-
tion switch is turned to the “OFF” position
(models with “keyless access with push-
button start system”).
. Immediately after the key is pulled out
(models without “keyless access with
push-button start system”).
. Immediately after any door is opened
when the push-button ignition switch is in
the “Acc” position (models with “keyless
access with push-button start system”).
If the indicator light does not blink, it may
indicate that immobilizer system is not
working properly. We recommend that you
contact your nearest SUBA RU deale r
immediately.
In case an unauthorized key is used, the
immobilizer indicator light illuminates.
& SI-DRIVE indicator light (if
equipped)
1) Intelligent (I) mode
2) Sport (S) mode
3) Sport Sharp (S#) mode
This light indicates the current SI-DRIVE
mode.
For details of SI-DRIVE mode, refer to “SI-
DRIVE” F7-25.
& Select lever/gear position in-
dicator
This indicator shows the position of the
shift lever (MT models) or select lever (AT
and CVT models).
! AT and CVT models
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to
“Automatic transmission/Continuously
variable transmission” F7-19.
! MT models
The shift-up indicator light illuminates and
informs the driver about the upshift timing
for fuel-efficient driving.
The gear position indicator and shift-up
To Next Page
Loading...
