Black plate (401,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
3. Remove the clip from the fender lining.
Refer to “Type B clips” F11-9.
4. Pull off the fender lining.
Engine hood
To open the hood:
1. If the wiper blades are lifted off the
windshield, return them to their original
positions.
2. Pull the hood lock release knob under
the instrument panel.
3. Release the secondary hood release
by moving the lever between the front
grille and the hood toward the left.
4. Lift up the hood.
To close the hood:
1. Lower the hood to a height of approxi-
mately 15 cm (5.9 in) above its closed
position and then let it drop.
2. After closing the hood, be sure the
hood is securely locked.
If this does not close the hood, release it
from a slightly higher position. Do not push
thehoodforciblytocloseit.Itcould
deform the metal.
Maintenance and service 11-11
– CONTINUED –
11
To Next Page
Loading...
