Black plate (102,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
2-6 Keys and doors
& Locking and unlocking from
the inside
1) Lock
2) Unlock
To lock the door from the inside, rotate the
lock lever rearward. To unlock the door
from th e inside, rotate the lock lever
forward.
The red mark on the lock lever appears
when the door is unlocked.
Pull the inside door handle to open an
unlocked door.
Always make sure that all doors and the
rear gate (Station wagon ) are closed
before starting to drive.
NOTE
If your vehicle is equipped with the
double locking system and it is acti-
vated, the door will not be unlocked
even when you move the door lock
lever forward.
& Battery drainage prevention
function
If a door or the rear gate (Station wagon)
is not completely closed, the interior lights
will remain illuminated as a result. How-
ever, several lights are automatical ly
turned off by the battery drainage preven-
tion function to prevent the battery from
going dead. The following interior lights
are affected by this function.
Item
Switch
position
Automatically turning
off
Map lights DOOR
Approximately 20
minutes later
Dome light DOOR
Approximately 20
minutes later
Ignition
switch light
—
Approximately 20
minutes later
Door step
lights
— None
*
Cargo area
light
DOOR
Approximately 20
minutes later
*: The door step lights are not affected by the
battery drainage prevention function, so the
lights do not turn off automatically. To turn off
the lights, it is necessary that each door and the
rear gate (Station wagon) are completely
closed.
The operational/non-operational setting of
this function can be changed by a
SUBARU dealer. We recommend that
you contact the nearest SUBARU dealer
if you would like to change the setting.
NOTE
. The factory setting (default setting)
for this function is set as “operational”.
. When lea ving th e vehicle, please
make sure that all doors and the rear
gate are completely closed.
. For models with the push-button
ignition switch, the battery drainage
prevention function does not operate
while the ignition switch is in “Acc” or
“ON” position.
. For models without the push-button
ignition switch, the battery drainage
prevention function does not operate
while the key is in the ignition switch.
To Next Page
Loading...
