EasyManua.ls Logo

Subaru Outback 2011 - Starting Engine

Subaru Outback 2011
495 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (282,1)
Model "A2470GE-B" EDITED: 2010/ 9/ 24
7-6 Starting and operating
NOTE
Engine oil, engine coolant, brake fluid,
washer fluid and other fluid levels
should be checked daily, weekly or at
fuel stops.
Starting and stopping engine
(models without push-button
start system)
& Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 sec-
onds. If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
! MT models
! Petrol engine model
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
4. Turn the ignition switch to the ON
position and check the operation of the
warning and indicator lights. Refer to
Warning and indicator lights F3-16.
5. Turn the ignition switch to the START
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the eng ine doe s not start, try th e
following.
(1) Turn the ignition switch to the
LOCK position and wait for at least
10 seconds. After checking that the
parking brake is applied, turn the
ignition switch to the START position
while depressing the accelerator pedal
slightly (approximately a quarter of the
full stroke). Release the accelerator
pedal as soon as the engine starts.
(2) If this fails to start the engine, turn
the ignition switch back to the LOCK
position and wait for at least 10
seconds. Then fully depress the accel-
erator pe dal and turn the i gnition
switch to the START position. If the
engine starts, quickly release the
accelerator pedal.
(3) If this fails to start the engine, turn
the ignition switch again to the LOCK
position. After waiting for 10 seconds
or longer, turn the ignition switch to the
START position without depressing
the accelerator pedal.
(4) If the engine still does not start, we
recommend that you contact your
nearest SUBARU dealer for assis-
tance.

Table of Contents

Related product manuals