Black plate (291,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
! AT and CVT models
1) Operation indicator
2) Push-button ignition switch
When the push-button ignition switch is
pressed while depressing the brake pedal,
the engine will start. The starting proce-
dure of the engine is as follows.
1. Carry the access key, and sit in the
driver’s seat.
2. Apply the parking brake.
3. Shift the select lever in the “P” posi-
tion. The engine can also start when the
select lever is in the “N” position, however,
for safety reasons, start in the “P” position.
4. De press the brake pedal until the
operation indicator on the pu sh-button
ignition switch turns green. When starting
with the select lever in the “N” position, the
indicator does not turn green.
5. While depressing the brake pedal,
press the push-button ignition switch.
NOTE
. In case the engine does not start by
the normal engine start p rocedure,
move the select lever to the “P” posi-
tion, and switch the power to “Acc”.
Depress the brake pedal, and press the
push-button ignition switch for at least
15 seconds. The engine may start. Only
use this engine start procedure in case
of emergency.
. When the engine is not started, the
brake pedal may feel stiff. In such a
case, depress the brake pedal more
forcefully than usual. Check that the
operation indicator on the push-button
ignition switch turns green, and press
the push-button ignition switch to start
the engine.
. For non-turbo models, to protect the
engine/transmission while the select
lever is in the “P” or “N” position, the
engine is controlled so that the engine
speed may not become too high even if
the accelerator pe dal is depressed
hard.
& Stopping engine
1. Stop the vehicle completely.
2. Move the select l ever to the “P”
position (AT and CVT models).
3. Press the push-button ignition switch.
The engine will stop, and the power will be
switched to “OFF”.
WARNING
. Do not touch the push-button
ignition switch during driving.
When the push-button ignition
switch is pressed for 3 seconds
or longer, the engine will stop.
When the engine stops, the brake
booster will not function. A great-
er foot pressure will be required
on the brake pedal.
The power steering system will
not operate either. A grea ter
force will be required to steer,
and it may result in an unex-
pected accident.
. If the engine stops during driving,
do not operate the push-button
ignition switch or open any of the
doors until the vehicle is stopped
in a safe location. It is dangerous
because the steering lock may be
activated. Stop the vehicle in a
Starting and operating 7-15
– CONTINUED –
7
To Next Page
Loading...
