Black plate (412,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
11-22 Maintenance and service
5. Pre heating indi cator ligh t will blink
approximately 5 seconds when the data
was reset successfully.
NOTE
. Each step between 1) through 6)
must be operated within 4 seconds.
. If the resetting procedure was un-
successful, repeat steps 1) through 5)
after performing the following items.
– Wait for 30 seconds with engine
idling.
– Turn the engine off, and restart
the engine after waiting 15 seconds.
& Recommended grade and
viscosity
CAUTION
Use only engine oil with the recom-
mended grade and viscosity.
Refer to “Engine oil” F12-6.
NOTE
Engine oil viscosity (thickness) affects
fuel economy. Oils of lower viscosity
provide better fuel economy. However,
in hot weather, oil of higher viscosity is
required to properly lubricate the en-
gine.
& Synthetic oil
You can use synthetic engine oil that
meets the same requirements given for
conventional engine oil. When using
synthetic oil, you must use oil of the same
classification, viscosity and grade shown
in this Owner’s Manual. Refer to “Lubri-
cants” F12-6. Also, you must follow the oil
and filter changing intervals shown in the
maintenance schedule. Refer to “Mainte-
nance schedule” F11-3.
NOTE
Synthetic oil of the grade and viscosity
noted in chapter 12 is the recom-
mended engine oil for optimum engine
performance. Conventional oil may be
used with no detriment to engine dur-
ability or driveability.
To Next Page
Loading...
