Subaru Outback 2011 - Rear Fog Light (Outback - if Equipped); License Plate Light

Black plate (455,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
3. Turn the bulb socket counterclockwise
and remove it.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Install the bulb socket by turning it
clockwise.
6. Reinstall the trunk trim lining.
& Rear fog light (Outback – if
equipped)
1. Turn the socket located behind the
rear bumper counterclockwise, and then
pull it out to remove.
2. Pull the bulb out of the bulb socket and
replace it with a new one.
3. Install the bulb socket by turning it
clockwise.
& License plate light
! Sedan
NOTE
It may be difficult to replace the bulbs.
We recommend that you have the bulbs
replaced by your SUBARU dealer if
necessary.
1. Open the trunk.
Maintenance and service 11-65
– CONTINUED –
11