Black plate (169,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
indicator can be activated or deactivated
by performing the following procedure.
1. Turn the ignition switch to the “LOCK”/
“OFF” position.
2. Press the trip knob to show “
” or
“
” on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
*
1
: “ ” or “ ” and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
*
2
: MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. The initial setting for your vehicle of
the gear position indicator/shift-up in-
dicator has been set for activation
“
” at the time of shipment from the
factory.
. It is not possible to change the
setting of the gear position indicator/
shift-up indicator when the ignition
switch is in the “ON” position. Change
the setting when the ignition switch is
in the “LOCK”/“OFF” or “Acc” posi-
tion.
& Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to “Front turn signal light” F 11-61 or
“Rear combination lights” F11-62.
& High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
& Cruise control indica-
tor light (if equipped)
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the “ON” position and turns off after
approximately 3 seconds.
This light illuminates when the “CRUISE”
main switch is pressed.
NOTE
. If you press the main switch button
while turning the ignition switch “ON”,
the cruise control function is deacti-
vated and the cruise control indicator
light “CRUISE” flashes. To reactivate
the cruise control function, turn the
ignition switch back to the “Acc” or
“LOCK”/“OFF” position, and then turn
it again to the “ON” position.
. If this indicator light and the mal-
function indicator lamp “
” flash
simultaneously during driving, we re-
commend that you have the vehicle
checked by your nea rest SUBARU
dealer.
Instruments and controls 3-37
– CONTINUED –
3
To Next Page
Loading...
