Black plate (322,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
7-46 Starting and operating
U.K. models
When the difference between the actual
vehicle speed and the set speed is less
than 4 mph (6.8 km/h), the set speed can
be lowered 1 mph (1.6 km/h) each time by
pressing the “ RES/SET” switch to the
“SET” side quickly.
Except U.K. models
When the difference between the actual
vehicle speed and the set speed is less
than 4.4 km/h (3 mph), the set speed can
be lowered 1 km/h (0.6 mph) each time by
pressing the “ RES/SET” switch to the
“SET” side quickly.
! To decrease the speed (by brake
pedal)
1. Depress the brake pedal to release
cruise control temporarily.
2. When the speed decreases to the
desired spee d, press the “RE S/SET”
switch to the “SET” side once. Now the
desired speed is set and the vehicle will
keep running at that speed without de-
pressing the accelerator pedal.
& Cruise control indicator light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the “ON” position and turns off after
approximately 3 seconds.
The light illuminates when the “CRUISE”
main switch is pressed.
NOTE
. If you press the “CRUISE” mai n
switch button while turning the ignition
switch “ON”, the cruise control func-
tion is deactivated and the cruise
control indicator light flashes. To re-
activate the cruise control function,
turn the ignition switch back to the
“Acc” or “LOCK”/“OFF” position, and
then turn it again to the “ON” position.
. If this indicator light and the mal-
function indicator lamp “
” flash
simultaneously during driving, we re-
commend that you have the vehicle
checked by your nea rest SUBARU
dealer.
. If this indicator light does not illumi-
nate even when you press the
“CRUISE” main switch, the cruise con-
trol system may not operate properly.
We recommend that you have your
vehicle checked by your nearest
SUBARU dealer.
To Next Page
Loading...
