Black plate (254,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
6-4 Interior equipment
Models without sunroof
To turn on the map light, press the switch.
To turn it off, press the switch again.
When leaving the vehicle, make sure the
lights are turned off to avoid battery
discharge.
! Door interlock switch
1) Door interlock switch
Although the map light switches are in the
OFF position (manually off), the map lights
can be set to illuminate automatically in
conjunction with a door opening, etc. by
use of the door interlock switch. The door
interlock switch has the following two
positions.
OFF: The map lights do not illuminate
automatically in conjunction with a door
opening. But, the lights can be turned on
manually by pressi ng the map light
switches.
DOOR: The map lights illuminate auto-
matically in the following cases.
. Any of the doors other than the rear
gate is opened. (The map lights do not
illuminate when only the rear gate is
opened.)
. The doors are u nloc ked using the
keyless access function (if equipped).
Refer to “Locking and unlocking with
“keyless access” entry function” F2-11.
. The doors are u nloc ked using the
remote keyless entry system. Refer to
“Locking and unlocking doors by remote
keyless entry system (locking and unlock-
ing by buttons)” F2-15 or “Remote key-
less entry system” F2-20.
. The ignition switch is turned from the
“Acc” position to the “LOCK”/“OFF” posi-
tion.
The automatically illuminated map lights
remain on for several seconds and then
gradually turn off after all doors are
closed. While the lights are on, if any of
the following operations are performed,
the map lights turn off immediately.
. The ignition switch is turned from the
“LOCK”/“OFF” position to the “Acc” or
“ON” position.
. All doors are locked using the keyless
access function (if equipped).
. All doors are locked using the remote
keyless entry transmitter.
The setting of the period for which the
lights remain on (OFF delay timer) can be
To Next Page
Loading...
