Black plate (453,1)
一般Model "A2470GE-B" EDITED: 2010/ 9/ 24
4. Slide the rear combination light as-
sembly straight rearward and remove it
from the vehicle.
1) Tail light
2) Brake light
3) Rear turn signal light
5. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
6. Pull the bulb out of the bulb holder and
replace it with a new one.
7. Set the bulb holder in to the rear
combination light assembly and turn it
clockwise until it locks.
8. Reinstall the rear combination light
assembly by sliding the two-pronged part
of the combination light assembly securely
to each holder of the vehicle side.
9. Tighten the upper and lower screws.
10. Reinstall the side cover.
Maintenance and service 11-63
– CONTINUED –
11
To Next Page
Loading...
