6-34 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
7. Choose Yes to confirm.
The remaining capacity of the logical drive is automatically allotted to the next
partition. In the following figure, a partition size of 20000 MB was entered; the
remaining storage of 14476 MB is allocated to the partition below the newly-created
partition.
8. Repeat Step 5 through Step 7 to partition the remaining capacity of your logical
drive.
You can create up to 128 partitions per logical drive, with a total number of
partitions not to exceed 1024 partitions per RAID array, including expansion units.
Note – When you modify a partition or logical drive size, you must reconfigure all
host LUN mappings. All the host LUN mappings are removed with any change to
partition capacity. See “Using the Map Host LUN Option” on page 6-37.
Note – When a partition of a logical drive or logical volume is deleted, the capacity
of the deleted partition is added to the partition above the deleted partition.
To Next Page
Loading...
Need help?
General
